How To Install Toilet Flange Spacer

If you’re looking to install a toilet flange spacer, it’s a fairly simple process. You’ll need to remove the old flange and then use a hacksaw to cut the new flange to size. After that, use plumbers putty to attach the flange to the toilet base and then reattach the toilet.

How To Install Toilet Flange Spacer

Toilet flange spacers are used to keep the toilet flange from sitting directly on the finished floor. Spacers are also known as washers and are placed between the flange and the floor. This will create a space for water to flow under the flange and help keep your flooring from becoming wet.

below -toilet flange spacer -level -tape measure -pencil -chisel -hammer -screwdriver -pliers

  • Place flange spacer on existing toilet flange
  • Install new wax ring over flange spacer
  • Set toilet bowl on top of wax ring tighten bolts on toilet bowl until snug

-If you are installing a new toilet, you will need to install the toilet flange spacer -To do this, remove the old flange and measure the distance from the top of the pipe to the bottom of the hole in the floor. -Then, use a hacksaw to cut a piece of PVC pipe that is that same length -Next, using PVC primer and cement, glue the spacer onto the end of the pipe -Finally


Frequently Asked Questions

Do Flange Extenders Work?

There is no definitive answer to this question as it depends on a number of factors, such as the type and size of flange extenders used, the materials from which they are made, and the strength of the connection between the flange extenders and the flanges themselves. Generally speaking, however, it is likely that flange extenders will work if they are properly installed and if the connection between them and the flanges is sufficiently strong.

How Does A Toilet Flange Extender Work?

A toilet flange extender is a device that is placed between the floor and the toilet flange in order to raise the height of the flange. This is necessary when the flooring material is thicker than the original flange height. The extender increases the height of the flange so that the toilet can be properly mounted.

How Do You Install A Toilet Extender?

There are a few ways to install a toilet extender, but the most common is by using screws or adhesive. First, find the spot on the wall where you want to install the extender and mark it with a pencil. Then use a drill or screwdriver to put in the screws (if using screws) or adhere the extender with adhesive. Once it’s in place, put the toilet seat on top of it and viola – you’re done!

How Do You Install A Toilet When The Flange Is Too Low?

One way to install a toilet when the flange is too low is to use a toilet flange extension. This is a piece of hardware that attaches to the toilet flange and raises it up so that the toilet can be installed properly.

Can You Stack Toilet Flange Spacers?

Yes, you can stack toilet flange spacers.

Can You Double Up Wax Rings On Toilet?

Yes, you can double up wax rings on a toilet.

How Does A Flange Extension Work?

A flange extension works by attaching to an existing flange and extending the flange out. This allows for a new pipe to be attached to the existing flange, which then can be used to extend the piping system.

What Do I Do If My Toilet Flange Is Too Low?

If the toilet flange is too low, you can either raise the flange or replace it.


To Review

A toilet flange spacer is a helpful tool for properly installing and aligning a toilet flange with the drain pipe. The spacer can be made from a variety of materials, such as metal or plastic, and is simply inserted between the flange and the drain pipe to achieve the correct spacing.

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *