How To Un Solder Copper Pipe

There are a few ways to un solder copper pipe. One way is to use a propane torch. Another way is to use a solder sucker.

How To Un Solder Copper Pipe

There are a few ways to unsolder copper pipe. One way is to use a propane torch. Turn the torch on to full heat and hold it about an inch from the solder. Heat the solder until it liquefies and flows away from the pipe. Another way to unsolder copper pipe is to use a soldering iron. Turn the soldering iron on to full heat and hold it against the solder. Heat the solder until it liquefies and flows away from

-copper pipe -solder -flux -tin snips -propane torch -butane torch -steel wool -sandpaper -wire brush

  • turn off the water supply to the pipe you are working on. 2. cut the pipe to be unsoldered using a pipe cutter. 3. heat the solder joint with a soldering iron until the solder

-When unsoldering copper pipe, it is important to have the right tools for the job. You will need a soldering iron, solder, flux, and a wet cloth. -First, cut the pipe to be unsoldered using a pipe cutter. If you are not sure how to use a pipe cutter, please consult a professional. -Next, apply flux to the end of the pipe that will be soldered. This will help the solder adhere to the metal


Frequently Asked Questions

Can Soldered Copper Fittings Be Reused?

Yes, copper fittings that have been soldered can be reused as long as they are still in good condition.

How Do You Remove Solder From Copper Fittings?

The easiest way to remove solder from copper fittings is to use a solder sucker. This is a small hand-held tool that has a rubber bulb on the end. When you squeeze the bulb, the air inside the bulb forces the solder out of the fitting.

Can Solder Be Removed From Copper Pipe?

Yes, solder can be removed from copper pipe using a flux and a soldering iron. The flux will help to dissolve the solder, and the soldering iron will provide heat to soften the solder and allow it to be removed.


To Review

Unsoldering copper pipe is a relatively easy process that can be completed with a few simple tools. First, turn off the water supply to the pipe and then cut the pipe in two places using a hacksaw. Next, use a pair of pliers to remove the fitting from one end of the pipe. Finally, use a soldering iron to melt the solder off of the fitting and then remove it from the other end of the pipe.

Similar Posts

Leave a Reply

Your email address will not be published.